Microsoft Office Error 1907

Microsoft Office Error 1907

 

Error 1907 during installation

RAPID PUBLISHING ARTICLES PROVIDE INFORMATION DIRECTLY FROM WITHIN THE MICROSOFT SUPPORT ORGANIZATION. THE INFORMATION CONTAINED HEREIN IS CREATED IN RESPONSE TO EMERGING OR UNIQUE TOPICS, OR IS INTENDED SUPPLEMENT OTHER KNOWLEDGE BASE INFORMATION.
During the installation of Microsoft Expression Web 2 or Microsoft Expression Studio 2 you may
encounter an error 1907 registering a font file. The log file should contain a line
similar to the following:3:48:25 PM Friday, July 18, 2008: MSI(ERROR): ‘Error 1907.Could not register font.
Verify that you have sufficient permissions to install fonts, and that the system
supports this font.’

Resolution:

To resolve this problem:

If you are not a system administrator,perform steps 1 – 5. If you are a system administrator perform step 1 and then skip to step 5.

  1. Browse for Start –> Programs –> Accessories.
  2. Right Click on Command Prompt.
  3. Click Run As:
  4. Click The Following User and enter the credentials of a system administrator. and click OK.
  5. In the command window, type:SFC /SCANNOW
  6. Allow the system to scan and reboot if it asks you to. The scan may also ask you to
    insert the operating system disc that you originally installed from, so you need to have that nearby.After this scan is completed, run the installation of Expression Web 2 or Expression Studio 2 again.

Disclaimer:

MICROSOFT AND/OR ITS SUPPLIERS MAKE NO REPRESENTATIONS OR WARRANTIES ABOUT THE SUITABILITY, RELIABILITY OR ACCURACY OF THE INFORMATION CONTAINED IN THE DOCUMENTS AND RELATED GRAPHICS PUBLISHED ON THIS WEBSITE (THE “MATERIALS”) FOR ANY PURPOSE. THE MATERIALS MAY INCLUDE TECHNICAL INACCURACIES OR TYPOGRAPHICAL ERRORS AND MAY BE REVISED AT ANY TIME WITHOUT NOTICE.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, MICROSOFT AND/OR ITS SUPPLIERS DISCLAIM AND EXCLUDE ALL REPRESENTATIONS, WARRANTIES, AND CONDITIONS WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO REPRESENTATIONS, WARRANTIES, OR CONDITIONS OF TITLE, NON INFRINGEMENT, SATISFACTORY CONDITION OR QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE MATERIALS.

 

You may browse to the location below take a backup of the fntcache.dat file and rename the file to old and check if Office application works fine as expected.

 

Here is the location of fntcache.dat file: C:\Windows:\ServiceProfiles:\LocalService:\Appdata:\Local

Refer the following steps to browse:

a) Click Start, open Computer,

b) Open C: drive, open Windows

c) Open ServiceProfiles, Open LocalService

d) Open Appdata, open Local

e) Here you see fntcache.dat file.

I hope the above information helps. Let us know if you need further assistance.

 


Leave a Reply

Your email address will not be published. Required fields are marked *